A handful of plants, led by the large campuses, produce most of the roughly USD 12 billion turnover of Turkey’s pharmaceutical industry. The backbone process steps — granulation, fluid bed drying (FBD) and film coating — are solvent-based, and on site ethanol, IPA and acetone are the solvents most often encountered. NFPA 497 classifies these solvent areas as Class I Division 1–2, which is considered comparable to ATEX Zones 0-1-2.

Solvent Chemistry

  • Ethanol: Flash point 13 °C, LEL 3.3% — the main granulation solvent
  • IPA (isopropyl alcohol): Flash point 12 °C, LEL 2% — common in tablet coating
  • Acetone: Flash point -20 °C, LEL 2.5% — already above its flash point at room temperature
  • Methanol: Flash point 12 °C, LEL 6% — its invisible flame is a separate hazard
  • DCM (dichloromethane): Halogenated and non-flammable, but its thermal decomposition products are toxic

Area Classification under NFPA 497

  • Solvent tank: Zone 0 inside, Zone 1 around it (within the bund)

Sprinklers in Pharmaceutical Plants

  • Granulation area: Nitrogen inerting plus CO2 suppression
  • Clean room: Preaction system — an accidental discharge would be a disaster for GMP
  • Warehouse: ESFR K25.2 (K360) — the standard choice for palletized rack storage

Examples from Turkey

  • A large pharmaceutical campus: 300,000 m² of covered area, Turkey’s largest production campus
  • A pharmaceutical plant: 100,000 m², a reference plant with solvent-based granulation lines
  • A biotechnology plant: Insulin production, one of the pilot sites on the biotechnology side
  • A pharmaceutical plant in the US: Dust explosion, 1 dead — a reference case in the industry’s memory in the US
  • EU GMP Annex 1: Current guidance for sterile manufacturing that also intersects with fire design

MEP Calc — 110+ Engineering Calculators

MEP Calc bundles 110+ engineering modules in one iOS app: 21 fire calculations (sprinkler, fire pump, clean agent) plus heating, cooling, HVAC, plumbing, steam and natural gas. Download it on the App Store.

Download MEP Calc on the App Store

SprinkCalc — Fire Sprinkler Design Across Three Standards

SprinkCalc covers hazard classification, design density and area, K-factor selection, water demand and hydraulic calculations for NFPA 13, FM Global and BS EN 12845 in a single iOS app, and exports a professional PDF report. One of the few tools that unifies all three major fire protection standards.

Download SprinkCalc on the App Store
Sources & Further Reading

NFPA 497, NFPA 77, EU GMP Annex 1, ATEX 2014/34/EU, FDA 21 CFR 211. NFPA 497 Classification of Flammable Liquids.