AFFF, AR-AFFF and F3 Foam Compared
AFFF, AR-AFFF and fluorine-free F3 foams compared: hydrocarbon and polar solvent performance, PFAS legislation, concentration, cost and C8 to F3 conversion.
Side-by-side comparisons of fire protection standards, systems and sprinkler types, with the clause references on both sides.
AFFF, AR-AFFF and fluorine-free F3 foams compared: hydrocarbon and polar solvent performance, PFAS legislation, concentration, cost and C8 to F3 conversion.
A comparison of electric and diesel fire pumps: mains dependence, first cost, pump room area, ventilation, test regime, maintenance burden and the rule...
A comparison of the ESFR, CMSA and CMDA sprinkler modes: objective, K-factor, operating pressure, number of operating sprinklers, ceiling slope limit,...
Mapping storage commodity classification across three standards: NFPA Class I-IV and Group A plastics, EN 12845 Category I-IV and material factor, FM...
A comparison of gaseous suppression systems: FM200, NOVEC 1230, IG-541 and CO2. Suppression mechanism, design concentration, occupant safety, cylinder...
A full comparison of the NFPA 13, BS EN 12845 and FM Global sprinkler standards: unit systems, density and area, K-factor notation, water supply...
A row-by-row comparison of NFPA 20 and EN 12845 pump requirements: the overload protection ban, starting method, cranking, batteries, fuel volume,...
A comparison of smoke detectors: point, beam and aspirating systems. Operating principle, ceiling height, coverage, sensitivity, response...
A comparison of sprinkler pipe materials: permitted hazard classes, Hazen-Williams C coefficient, jointing methods, corrosion resistance, wall...
A complete sprinkler temperature rating table: glass bulb and fusible link colour codes in separate columns, the ambient plus 30 C selection rule,...
A complete sprinkler K-factor table: metric (K60 to K480) against US units (K4.2 to K33.6), K-factor ranges, thread types, typical use, minimum pressures and a...
A comparison of the four sprinkler installation types: medium in the pipe, water delivery time, design area increase, corrosion and maintenance burden,...