Mechanical seal fires are a frequent risk scenario in refineries and petrochemical plants. A high-pressure hydrocarbon leak instantly becomes a jet fire — a fire column 5–10 m tall under the pump skid. API 2218 (Fireproofing Practices in Petroleum and Petrochemical Processing Plants) defines structural protection, pump secondary containment and deluge spray water design.

Seal Failure Modes

  • Primary seal wear: dry running, abrasive fluid
  • Secondary seal failure: flammable liquid escapes to atmosphere
  • Pump cavitation: excess vibration, shaft misalignment, bearing damage
  • Ignition: hot surface (autoignition temperature > 350 °C / 662 °F) or spark

Typical API 610 pump seal life in the field is 3–5 years; without periodic vibration and temperature monitoring it ends much sooner.

Firesafe Secondary Seal

  • Dual mechanical seal: two primary seals with barrier fluid between them
  • API Plan 52/53: external flush + barrier fluid circulation
  • API Plan 66: secondary containment + drain
  • Magnetic drive pump: no seal — no leak

Deluge Spray Water

Deluge around the pump skid, typical parameters:

  • Design density: at least 20.4 L/min/m² (0.50 gpm/ft²) over the projected surface of the pump and related equipment (NFPA 15 7.3.2)
  • Area: pump casing, motor and discharge valve
  • Nozzle: medium-velocity spray, 60° cone
  • Activation: flame detector (UV/IR), gas detector or manual
  • Water reserve: 30 min (subject to AHJ approval) or 2 hours (FM Global)

Structural Fireproofing

  • Structural steel: PFP (passive fire protection) - intumescent coating, 2-hour rating
  • Cable tray: ablative coating or mineral wool
  • Pipe support: fireproof concrete coating up to 9 m (30 ft) above grade
  • ESD valve: closes on heat or smoke in 30 s

MEP Calc — 110+ Engineering Calculators

MEP Calc bundles 110+ engineering modules in one iOS app: 21 fire calculations (sprinkler, fire pump, clean agent) plus heating, cooling, HVAC, plumbing, steam and natural gas. Download it on the App Store.

Download MEP Calc on the App Store

SprinkCalc — Fire Sprinkler Design Across Three Standards

SprinkCalc covers hazard classification, design density and area, K-factor selection, water demand and hydraulic calculations for NFPA 13, FM Global and BS EN 12845 in a single iOS app, and exports a professional PDF report. One of the few tools that unifies all three major fire protection standards.

Download SprinkCalc on the App Store
Sources & Further Reading

API 2218, API 610, API 682, NFPA 15, NFPA 30, FM Global DS 7-88. API 2218 Petroleum Fireproofing.